a little tuning co 325 views   1 clicks Claim this Business♡

Make the most out of your new strut mounts and replace the upper strut bearing while you're in there. These front bearings see a lot of load from the front of the car, and will wear and become noisy over time. This simple replacement will make for improved ride quality when refreshing your front sus...

034Motorsport Solid Aluminum Subframe Bushing Upgrade Kit for the MkIV Volkswagen R32 and 8L/8N Chassis Audi Quattro cars. Our billet aluminum subframe mounts are designed as a direct replacement for the factory rubber subframe mounts, and lock down the rear subframe.The factory rear subframe bushin...

We're pleased to announce the availability of our Density Line/Motorsport Hybrid Bundle Motor Mount Set for the MkIV Volkswagen and 8L/8N Audi chassis!034Motorsport has assembled the Density Line/Motorsport Hybrid Bundle for the serious trackday guru and seeker of ultimate performance. This kit incl...

We're proud to announce the availability of the Motorsport Billet Dogbone Mount for MkIV chassis Volkswagen and 8L & 8N chassis Audi models!034Motorsport's Motorsport Dogbone Mount is the new standard in performance and durability. This dogbone mount was designed with performance in mind, manufactur...

High rate dual valve spring set for the 24v VR6, includes spring seats and Ti retainers which allow for higher lift than stock retainers, at half the weight.Specs:- 13.90mm max lift- Coil bind at 17mm- Rate 12.6lbs/mmPrice for one complete set, enough for one engine.

Valve set for the 24v and R32 motors, stock size for the R32. Back cut and swirl polished valves for higher flow. Intake valves are stainless steel with a nitride coating, exhaust valves are Inconel for turbocharger use.Great upgrade for either the 24v or R32 motor looking to get more flow and under...

Finally, an affordable head stud set for the 24v VR6, we build this set using ARP hardware, this is not an "off the shelf" ARP kit. Features 11mm studs with nuts, washers and ARP moly lube. Does not fit the R32 motor w/o modifications, the R32 uses 10mm studs, to fit on an R32 the block must be tapp...

This oil filter housing adapter allows the use of an external oil cooler, and remotely mounted oil filter. Large threaded holes are 7/8" x 14 which is -10 AN thread pitch, any o-ring seal -10 bung will thread right in.Also features Q2 - 1/8" npt threaded holes for turbo oil feed, oil temp, oil press...