Control Tee Handle - Twist Lock

A simple tee handle on a 9mm shaft, housed in a mounting tube with an outside diameter of 16mm for bulkhead/wall mounting.

Unit measures 280mm overall (including tee handle).

Aslight twist action of the tee locks the position releases when the tee is turned in the opposite direction Very little twisting action is required.

A special cable is applied to these handles (pictured). It is additional if fitting in a new installation, we make these to suit. They can either have a conventional 3/16" UNF thread (10-32 UNF thread) that is the same as a 33c throttle/gear cable on the outer end (other end has to be suited to the vernier so no options at that end) or bare wire (that passes through a conventional nylon outer) that can be wrapped around your existing carburator, or throttle. Allow 7-9 working days.