MAGIGOO® Supergrip

For more specific settings, check out our l ist of tested materials. How to Apply

- Shake the MAGIGOO® pen like you mean it
- Press the nib (end of your pen) on the printing bed for MAGIGOO® to flow.
- Spread the adhesive evenly on the printing area(cover your bed with an even thin layer).
- Make sure that no spots are missed.

It’s best to apply MAGIGOO® when the printing bed is still cold, but it will also work when the printing bed is already hot. Make sure to use MAGIGOO® with the suggested plastics and with a correctly levelled bed and suitable printing settings. Squeeze bottle gently only when the nib is pressed against the bed. Keep the nib away from dirt.

After your prints have finished and popped off, clean the cool printing bed by wiping it with a damp cloth. Use just water.

Magigoo Original can be applied to commonly used 3D printing surface such as glass, PEI, Buildtak, Powder coated flex plates, Kapton tape and others.

For more tips and tricks on 3D Printing and using Magigoo, kindly refer to the Magigoo Manual.

MAGIGOO® is best stored upright, with the cap closed and away from direct sunlight. MAGIGOO® was specifically designed for mobility, which is good news if you want to take it with you on-the-go.