Get Electronic 214 views   3 clicks ♡

This is a repair service to remove and replace the Turbine speed sensor assembly#26709

This item is a ZF 8HP45 transmission control unit (TCU/TCM). It is a conductor plate used in 8-speed automatic transmissions for various vehicles, including BMW, Audi, and Land Rover models.Common issue with the range sensor on these unitsFunction: It manages gear shifts by controlling the transmiss...

This is a repair service for harsh shifting Mark X TCMS-Common part number but not limited to89661-2A23089661-3F150275000-8664or Lexus GS seriesYou MUST do a relearn shift alignment after the repair serviceIf the customer can NOT DO THIS, WE CAN NOT OFFER THEM THE SERVICEThis is a very invasive, com...

This is a service to fully dismantle and repair the internals of the switch contacts#26731

transmission control module for 722.9This control module commonly has a fault with the speed sensorsA 033 545 73 32VAS2-NAG25WP2 1101 K04

This is a series of shifter that can have a Problem with the Movement lock assemblyPart numberXX23-7E453-GC

This is a service to clone the data of this TCM to another module#26781

Please remove the TCM from the Valve body.We would charge Extra to remove this for youThis is a repair service for this TCMThese part numbers are not limmited too, just need to visually look the same00401065C0CU500143D212060763420 AM 927769D0AM 927 769 0AM927 769D / 0AM927 769K / 0AM927 769G: 0AM927...

This is a repair service for this ECU that commonly suffers form Transmition control issuesPart numbers are not limmited too89666-22061275100-7510#26358

This is a test-and-repair service for this TCM module, where we test the turbine speed sensor for faults and replace it if needed. both setsA 033 545 73 32VAS2-NAG208228205WP2 11 01 K04

This is a repair listing for a Rav 4 TCM unit (typically behind the cabin glovebox )Rav 4 Harsh Shift - 211000-7020 89661-42620 1AZ-FSE 4X4 ATThe customer needs to perform a relearn after the repairs are complete. We replace all the shift drivers inside of the ECU; however, the programming needs to...

Parking switch not working

This is a clone-only service that we would offer on these TCMs.common part numbers are, but not limited to, as long as they have the same appearanceA2C53377498Continental GETRAG

This is a control module failure where the output drive is no longer functional,#26605

this is a repair service for this TCM module that has an intermittantNote these units need to be sawn open for the repair process to take place, We Epoxy shut the units after repair process has been completed#26597

This is a TCM module that we are able to copy the data from one unit to another, and also perform wire bond repairs to those associated with Speed Sensor or Park Range Sensor issues#26608

Mercedes 722.9 ISM Module Repair - Virginise, Clone & Bench TestThe Mercedes-Benz 722.9 (7G-Tronic) Intelligent Servo Module (ISM) controls gear selection logic and communication between the selector assembly and the transmission control system. Failures in this module can result in shift faults, se...

(VGS / FCVT / Autotronic)Turbine Speed Sensor & RPM Signal Faults - Full Refurbishment Bench TestThe Mercedes-Benz 722.8 Autotronic CVT Transmission Control Module (TCM) is a common failure point on A-Class (W169) and B-Class (W245) vehicles. These modules frequently develop internal faults that tri...

DQ250 Transmission Control Module (02E Mechatronic) – Repair Service:This service covers the full rebuild and restoration of your existing DQ250 TCM (Control Module). The DQ250, commonly found in Volkswagen, Audi, Skoda and Seat vehicles, is a complex transmission controller integrated with the va...

this is a repair service for the selectror switch failure contacts fail, we reinforce all contacts for a long life repair

this is a test service to ensure the TCM is comunicating to the Vechles systems

this is a common issue on most mech units where the pins themselves break off - we remove the stub and replace the pin

This is a repair sevice to Test and replace the pressure Sensor on the tcm unit

This is a service to Bench test the TCM from a mechatonic system