[R18+] "Midnight Sky" M4 Gel Ball Blaster [ID Check Required]

To purchase this item, you must be 18 years of age or older. After completing your purchase, you will receive a Real ID check verification email in your inbox. Check all categories of your inbox, such as your spam, updates, social folders.

Specifications:

Firing Range: 10-12 meters

Ammo Size: 7-8 mm

Features:

- Fully automatic firing mode
- Lightweight blaster
- The bullets are made of water polymer and easy to break
- Rechargeable lithium battery
- The pattern on the Gel Ball Blaster varies (It may be slightly different from the image listed)

Dimensions:

- Length of blaster body: 63cm
- Length of muzzle: 16cm Included:

- 1 x Small sachet of dehydrated gel balls
- 1 x Top fed pineapple-shaped magazine
- 1 x 7.4 volt rechargeable battery
- 1 x USB charging cable (4 pin)
- 1 x Safety glasses
- 1 x Muzzle Attaching the Nozzle Gap Alignment Guide

Identify the Alignment Points
Locate the big gap and small gap on both the front nozzle and the main blaster body. These gaps are designed to interlock and ensure proper orientation.

Align the Gaps
Line up the big gap on the nozzle with the big gap on the blaster body, and do the same for the small gap.
This step is critical — mismatched alignment may result in stress on the plastic during installation.

Install with a Gentle Twist
Once aligned, gently twist the front nozzle into place.
Turn only in the correct direction until all the outer segments lock flush with the blaster body.

Handle with Care
⚠️ Use extra caution during the initial twist.
Forcing or misaligning any of the three major parts (nozzle, body, buttstock) can cause cracks or permanent damage. Attaching the Buttstock
- Find the release button
To install the back part of the blaster you need to pull or push back a small button hidden somewhere nearby the buttstock. Once you find the button, hold it in such a way that maintains the opening of the blocking grips to allow you to slide the buttstock onto the main part of the blaster body.

Ensure that you use the motion of going from TOP to DOWN to clip it into place.

And when you take the blaster apart that the buttstock is removed by holding down that small button and you PULL the buttstock UPWARDS.