Interfaces to connect Victron Products to each other
The VE.Direct to VE.CAN interface connects products with a VE.Direct connection to products with a VE.Can connection so the products can communicate with each other.
The VE.Can RJ45 terminator comes in a bag of two when ordered separately. The terminators are also included with some products, for example, with the CANUSB.
The VE.Bus to VE.Can interface is used in Hub-1 systems with grid-feedback enabled. It interfaces between the VE.Bus system and one or more MPPT solar chargers with a VE.Can connection: the MPPT 150/70 and/or MPPT 150/85.
The Victron Energy Inverting remote on-off cable is intended for products that require an active pull-down of the remote control terminal to switch on, while the source signal turns high when the switch on is required.
With the non-inverting remote on-off cable, you can switch the Victron Inverter, which is connected with the MPPT Charge Controller, on/off through the load output of the MPPT Charge Controller.
VE.Direct non-inverting remote on-off cable is intended for on/off control of products with a VE.Direct interface.
(one exception: not applicable to the MPPT 75/15 and 100/15).
It will switch the product on when the source signal turns high and switch the product off when the source signal turns low or becomes free-floating.
0
0
The VE.Can RJ45 terminator comes in a bag of two when ordered separately. The terminators are also included with some products, for example, with the CANUSB.
The VE.Bus to VE.Can interface is used in Hub-1 systems with grid-feedback enabled. It interfaces between the VE.Bus system and one or more MPPT solar chargers with a VE.Can connection: the MPPT 150/70 and/or MPPT 150/85.
The Victron Energy Inverting remote on-off cable is intended for products that require an active pull-down of the remote control terminal to switch on, while the source signal turns high when the switch on is required.
With the non-inverting remote on-off cable, you can switch the Victron Inverter, which is connected with the MPPT Charge Controller, on/off through the load output of the MPPT Charge Controller.
VE.Direct non-inverting remote on-off cable is intended for on/off control of products with a VE.Direct interface.
(one exception: not applicable to the MPPT 75/15 and 100/15).
It will switch the product on when the source signal turns high and switch the product off when the source signal turns low or becomes free-floating.
×