Perun ETU++ (With T-Deans Plug)

ETU is a system that replaces the standard electronics in G&G replicas equipped with the ETU system. It enriches the replica with many new, useful features.

Simply disconnect the factory-installed electronic board in the stock and plug in the ETU. The factory contacts in the gearbox are preserved, so there is no need to open it.

It works with any replica equipped with the ETU system from G&G, as well as with 7.4V, 11.1V, and 14.8V Li-Po batteries.

- Freely programmable fire modes – Single, series or automatic fire can be set at any selector position (except “protected")
- Active brake – Stops the motor after each shot, preventing “whipping" of the spring, and in the case of faster replicas – does not allow overspin (double shot instead of single)
- Reduce rate of fire – Reduce the rate of fire on automatic fire or rounds to save ammunition or increase realism
- Precocking – A quick response to a trigger press can make the difference between winning and losing, especially during indoor battles
- Binary trigger – Allows for easy double shots in semi-automatic setting. After enabling this mode, if semi-automatic fire is set, shots will be fired not only when the trigger is pulled, but also when it is released
- DMR mode – Introduces minimum time intervals between shots to meet the requirements for DMR replicas at certain game sites