T-bar Dent Repair Puller Kit with Glue Tabs Suction Cup

The Dent Puller is made of selected strong alloy, 100% reliable in daily use. It was constructed by a short T puller, and an extended slide hammer bar. It can deal with different sizes dent.
Package Contents:

- 1 Dent Puller Tool
- 18 Car Dent Glue Tabs
- NOTE: The kit doesn't include Hot Glue Gun and Glue sticks, they can be bought separately on our website. How to use Car Dent Puller:

- First, review the damage on your car and if you are not sure where is the dent, please, check our Reflect Board that helps to detect the deformation.
- Once the dent is measured, clean the surface with alcohol.
- Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes
- Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the drawing gasket is, the larger the drawing force is);
- Pull the trigger and apply the drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue);
- Fast place the drawing gasket with hot melt glue at the centre of dent, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter);
- Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent;
- Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen;
- Clean the repaired place with a clean wet cloth.

If you are still not sure what is the best tool for you check our blog post How you can remove dents yourself with the right tools and patience.