Techstyle 9 views   8 clicks ♡

The Do Not Use! loads may be used if combined loads 1 through 4 do not exceed the 1920W limits and individual loads do not exceed the limits in the table.Vantage Controls products may only be purchased by Certified Installers. If you would like more information about becoming a Certified Installer o...

The Relay Station Lighting - DIN is designed to control lights and provides eight isolated latching relay channels. The RS8-L-DIN accepts voltage from 0 to 277 volts and up to 10amps at each load. The relays are single-pole, single throw, offering a set of eight latching contacts. This station may a...

The Relay Station - DIN provides relay for up to eight individual loads. Four SPST and four SPDT relays provide hardware interlock installations. Each of the eight relays are designed to handle up to ten amps of either high or low voltage current. Actuator buttons allow the connected relays to be ma...

Country of Origin China

The 0-10 PWM Low Voltage Output Station-DIN is used for the control and automation of LED, CLF and CCFL lighting loads requiring either 0-10 or PWM for dimming control.Each LVOS DIN features eight 0-10 outputs with four that can be turned into PWM outputs. The LVOS DIN is firmware upgradable in the...

The 0-10 PWM Low-voltage output station (LVOS) is used for the control and automation of LED, CFL, and CCFL lighting loads requiring either 0-10 or PWM for dimming control. The dry contact inputs can be used with motion sensors, light sensors, pressure sensors, IR inputs, magnetic switches, and more...