52mm CAN Digital Controller Gauge- Made In NZ

CAN Digital Display Gauge Overview

A high-performance CAN digital gauge designed to integrate directly with leading aftermarket ECUs. Built in a durable anodised 6061 aluminium housing, this unit delivers real-time engine data, advanced control features, fault monitoring, and full customisation — all in a compact 52mm form factor.

Whether you're tuning, racing, or building a serious street car, this display gives you complete visibility and control over your engine management system. Key Features

Anodised 6061 aluminium housing

46 live CAN data channels

Dual-point oscilloscope view

Fault code monitoring and clearing

ECM security access

Fully adjustable warnings & shift light

Adjustable units (PSI/Bar/kPa, °C/°F, KM/H/MPH)

Dim display input & brightness control

CAN output support ECU Control Functions (ECM Dependent)

Adjust boost level

Adjust traction control

Enable/disable antilag

Enable/disable launch control

Check engine light display

Display Screens

Boost Gauge

Dynamic Lambda Gauge

Tachometer

Multi-Gauge A, B & C

User Defined Gauges (x2)

Fault Code Monitor

Live Data View (All Channels)

Oscilloscope

ECM Control

Security & Settings Supported ECUs

Link Engine Management

Haltech

MaxxECU

Emtron

Ford Barra

Hondata

ECU Masters

Motorsport Electronics UK

Megasquirt

Edelbrock

(Displays only data available from the connected ECU.)

Data Channels Available (ECU Dependent)

The gauge can display a wide range of live CAN data including:

Boost / Manifold Pressure (with peak tracking)

Lambda (multiple channels overall)

RPM

Oil Pressure & Temperature

Coolant Pressure & Temperature

Fuel Pressure & Temperature

Injector Duty Cycle & Pulse Width

Ignition Timing

Ethanol Content

Throttle Position

Gear Position

Vehicle & Individual Wheel Speeds

Cam Positions

Exhaust Gas Temperatures (up to 8 channels)

Battery Voltage

ECU Temperature

And more (46 total parameters)

Fault codes can also be displayed directly on screen. Installation & Wiring

Supplied with a pre-terminated 6-pin harness.
Requires 12V nominal DC with 0.5A fused supply.

Wiring:

Black – Ground

Red – Ignition 12V

Orange – Dim Input

Yellow – CAN High

Green – CAN Low

Brown – Not Used Mounting

52mm body fits standard gauge holders

2x M3 threaded holes on rear (44mm centre-to-centre) for custom bracket mounting CAN Setup (Example – Link ECU)

Load supplied AIC CAN stream

CAN ID: 1000

Transmission Rate: 100Hz

Enable CAN output in ECU software