Get Electronic 307 views   4 clicks ♡

this is a repair service to replace the whole display unit

this tool typically fails where the USB Port enters-we can remove and replace this port and add extra stenghtening

This is a repair service where the touch glass is no longer responsive, and we replace this for you

This is a common diagnostic interface tool used with Volvo systems. A frequent fault we see is internal failure that causes it to short out the OBD port on the vehicle, potentially affecting other systems.If you're experiencing this issue, we can help. Our team can repair these tools and restore saf...

replacement buttons installed.all buttons replaced -2 year warranty on the repair

OBD 2 - 16 Pin Connector Male

Note, needs exturnal current load resistor to operateWR-005 50A 100V

This is a 1Ft OBD 2 - 16 Pin Connector Male - Female to make connections a bit easier in those Tight Spots when needed

Package Size 23 17 7.5cm / 9.05 6.7 2.95in (L W H)

Ideal for probing wires, in a very non-intrusive way.Connects using 4mm banana plug

This listing is for one receptacle and 5 replacement tips.

replacement buttons installed.all buttons replaced -2 year warranty on the repair

Handy LED resistance panel meter. Suitable for easily measurement resistance on the go in your project. Easy 4 wire interface. Connect to power, and across whatever you want to measure the resistance of. Red: 12V 60mABlack: GndYellow: ProbeBlue: Probe

J4A-M-DSN-VC288 RED / BLUE LED XK-001 DSN-VC288 100v 10ampsinternal current shunt

The DC battery monitor meter is mainly used to measure the voltage, current, resistance, internal resistance, capacity, SOC, energy consumption and running time of various types of batteries, and display the measurement data through the LCD screen. Monitor your battery faster and more comprehensivel...

M469D Cable lan tester Network Cable Tester RJ45 RJ11 RJ12 CAT5 UTP LAN Cable Tester Networking Tool network RepairTest of double-twisted cables: Switch on the power. (S is slow automatic grade, Mis manual.) Put cables into both main tester and remote tester. The lights of the main tester will turn...

(1) Output: ≤ 15mA (5.0)(2) Input: DC 4.2-6.0v(3) Output Signal: 1.5ms ± 0.5ms(4) Size: 46 32 17MM(5) Weight: 8g(6) Adjustment: manual, automatic, and the median.Features: the ability to easily detect and configure the server\'s virtual spaces, jitter and median.Can be connected to two servos or...